2021-11-11

Speaker - Headliner - LH (Remove and Replace)

Correction code 21214502 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 차량에서 헤드라이너를 탈거합니다. Headliner (Heat Pump) (Remove and Install)을(를) 참조하십시오.
  2. LH 전면 헤드라이너 스피커에서 방음 폼을 탈거합니다.
  3. LH 전면 헤드라이너 스피커 전기 커넥터를 연결 해제합니다.
  4. LH 전면 헤드라이너 스피커를 헤드라이너 어셈블리에 고정하는 나사를 탈거합니다.
    0.5 Nm (4 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 드라이버

Install

  1. LH 전면 헤드라이너 스피커를 헤드라이너 어셈블리에 배치한 다음 스피커를 헤드라이너 어셈블리에 고정하는 나사를 장착합니다.
    0.5 Nm (4 lbs-in)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T10 드라이버
  2. LH 전면 헤드라이너 스피커 전기 커넥터를 연결합니다.
  3. 흡음 폼을 LH 전면 헤드라이너 스피커에 장착합니다.
  4. 헤드라이너를 차량에 장착합니다. Headliner (Heat Pump) (Remove and Install)을(를) 참조하십시오.