2020-12-16

Trim - B-Pillar - Lower - LH (Remove and Replace)

Correction code 15183402 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. LH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
  2. LH 중간 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
  3. LH 하단 A필러 트림을 탈거합니다. Trim - A-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
  4. 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
  5. LH 2열 시트 사이드 볼스터를 탈거합니다. Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)을(를) 참조하십시오.
  6. LH 후면 실 패널 트림을 탈거합니다. Trim - Sill Panel - Rear - LH (Remove and Replace)을(를) 참조하십시오.
  7. LH 상단 B필러 트림을 차량에 고정하는 클립을 분리한 다음 트림을 한쪽으로 치워둡니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    LH 상단 B필러 트림 하단부를 차량 안쪽을 향해 당겨 하단 클립을 분리한 다음 트림 상단부를 당겨 남은 상단 클립을 분리합니다.
  8. LH 하단 B필러 트림을 차체에 고정하는 클립을 분리하고 차량에서 트림을 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    나머지 LH 하단 B필러 트림 클립을 LH B필러에서 모두 탈거하고, 나중에 LH 하단 B필러 트림을 장착하는 경우 트림에서 모든 클립을 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

  • 같은 LH 하단 B필러 트림을 재사용하는 경우 새 클립을 트림에 장착합니다.
  • LH 하단 B필러 트림 하단 가이드 탭을 슬롯과 정렬하고 하단 클립을 체결한 다음, 위쪽을 향해 작업하여 나머지 클립을 체결합니다.
  • 도어 씰이 LH 하단 B필러 트림과 겹치게 합니다.