Harness - USB - Car Computer to Glove Box (RHD) (Remove and Replace)
Correction code
17106852
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 전면 도어를 엽니다.
- LH 및 RH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 에어 웨이브 베젤 캡을 탈거합니다. End Cap - Air Wave - LH (Remove and Replace)을(를) 참조하십시오.
- 주 계기판 장식 트림을 탈거합니다. Decor Trim - Instrument Panel - Main (Remove and Replace)을(를) 참조하십시오.
- LH 중간 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
- LH 하단 A필러 트림을 탈거합니다. Trim - A-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
- 글로브박스를 탈거합니다. Glove Box - Without Knee Airbags (Remove and Replace)을(를) 참조하십시오.
-
LH 에어 웨이브 덕트 서미스터를 연결 해제합니다.
-
LH 에어 웨이브 덕트를 고정하는 클립(3개)을 탈거한 다음 덕트를 탈거합니다.
-
차량 컴퓨터에서 글로브박스 USB 케이블을 연결 해제합니다.
- 글로브박스 USB 하네스 클립(2개)을 분리하고 차량에서 하네스를 탈거합니다.
Installation procedure is the reverse of removal.