Module - HomeLink Transmitter (Remove and Replace)
Correction code
17154202
0.48
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2025-07-14: 교체 이후 루틴 지침을 업데이트했습니다.
Remove
-
12V 전원을 분리합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
경고홈링크 송신기와 터치스크린 아이콘의 예상치 않은 작동을 방지하려면 12V 차단 절차를 정확히 상세히 설명한 대로 수행하십시오.
- 전면 페시아를 탈거합니다. 참조 항목: Fascia - Front (Remove and Install).
-
HomeLink 송신기 모듈에서 전기 커넥터를 연결 해제합니다.
-
탭을 푼 다음 HomeLink 송신기 모듈을 오른쪽으로 밀어 차량에서 탈거합니다.
Install
-
HomeLink 송신기 모듈을 브래킷에 장착합니다.
-
전기 커넥터를 HomeLink 송신기 모듈에 연결합니다.
- 전면 페시아를 장착합니다. 참조 항목: Fascia - Front (Remove and Install).
- 12V 전원을 다시 연결합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
- 정비 모드 또는 Toolbox를 사용하여 다음 루틴을 수행합니다(참조 항목: 0005 - 정비 모드): TEST-SELF_VCFRONT_X_HOMELINKvia Toolbox: (link)via Service Mode: Low Voltage ➜ HomeLink ➜ Test HomeLink