Sensor - Pressure and Temperature (PT) - High Pressure (Non-Heat Pump) (Remove and Replace)
Correction code
18205502
1.44
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 후드 내 보관 유닛을 탈거합니다. 참조 항목: Underhood Storage Unit (Remove and Replace).
- A/C 냉매 회수를 수행합니다. 참조 항목: A/C Refrigerant (Recovery and Recharge).
- 외측 HVAC 플레넘 덕트를 탈거합니다. 참조 항목: 플레넘 - 인입 - HVAC(탈거 및 교체).
-
고압 및 온도 센서에서 전기 하네스를 연결 해제합니다.
-
방출 파이프에서 고압 및 온도 센서를 탈거합니다.7 Nm (5.2 lbs-ft)
Install
Installation procedure is the reverse of removal, except for the following:
- A/C 냉매 재충전을 수행합니다. A/C Refrigerant (Recovery and Recharge)을(를) 참조하십시오.
-
Toolbox 3이 설치된 노트북을 차량에 연결한 후 다음을 수행합니다.
-
Actions/Autodiag 탭에서 "reset vcfront"를 검색하고 TEST-RESET_VCFRONTvia Toolbox: (link)via Service Mode Plus:
- Low Voltage ➜ Power Distribution ➜ Reset VCFRONT
- Mid Voltage ➜ Power Distribution ➜ Reset VCFRONT
-
Actions/Autodiag 탭에서 "thermal"을 검색하고 TEST-SELF_VCFRONT_X_THERMAL-PERFORMANCEvia Toolbox: (link)via Service Mode: Thermal ➜ Actions ➜ Test Thermal Performancevia Service Mode Plus:
- Drive Inverter ➜ Front Drive Inverter Replacement ➜ Thermal System Test
- Drive Inverter ➜ Rear Drive Inverter Replacement ➜ Thermal System Test
- Drive Inverter ➜ Rear Left Drive Inverter Replacement ➜ Thermal System Test
- Drive Inverter ➜ Rear Right Drive Inverter Replacement ➜ Thermal System Test
- Drive Unit ➜ Front Drive Unit Replacement ➜ Thermal System Test
- Drive Unit ➜ Rear Drive Unit Replacement ➜ Thermal System Test
-
Actions/Autodiag 탭에서 "reset vcfront"를 검색하고 TEST-RESET_VCFRONTvia Toolbox: (link)via Service Mode Plus: