2023-08-03

Sun Visor - LH (Remove and Replace)

Correction code 15051002 0.06 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-07-20: 탈거 부분에 비디오를 추가했습니다.

Torque Specifications

표 1. Torque Specifications: Sun Visor - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
선바이저를 차량에 고정하는 볼트
3.5 Nm (2.6 lbs-ft)
  • Torx T25 소켓
  • ¼인치 표준 래칫
  • ¼인치 토크 렌치(장착 전용)
  • 2인치 익스텐션
Reuse

Remove

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  1. 선바이저 브래킷 커버를 차량에 고정하는 클립(4개)을 분리합니다.
  2. 선바이저를 차량에 고정하는 패스너를 탈거합니다.
    3.5 Nm (2.6 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T25 소켓
    • ¼인치 표준 래칫
    • ¼인치 토크 렌치(장착 전용)
    • 2인치 익스텐션
  3. 선바이저에서 전기 커넥터를 연결 해제합니다.
  4. 차량에서 선바이저를 탈거합니다.

Install

Installation procedure is the reverse of removal.