2025-04-04

Isolator - Motor Mount - Front - LH (Remove and Replace)

Correction code 30011022 2.88 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2025-03-26: 얼라인먼트 점검이 필요한지 여부와, 필요한 경우 어떤 종류의 얼라인먼트 점검이 필요한지에 대해 정의하는 서스펜션 얼라인먼트 표를 참조하는 단계를 추가했습니다.
  • 2024-11-25: O링 장착에 대한 참고 사항을 추가했습니다.

Remove

  1. 차량에서 전면 서브프레임 어셈블리를 탈거합니다. 참조 항목: Subframe Assembly - Front (Dual Motor) (Remove and Install).
  2. LH 전면 모터 마운트 아이솔레이터를 차체에 고정하는 볼트를 탈거하여 폐기한 다음 차량에서 아이솔레이터를 탈거합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    볼트를 풀면 아이솔레이터가 낙하하므로 볼트를 탈거하는 동안 LH 전면 모터 마운트 아이솔레이터를 고정하십시오.

Install

  1. 각 새 볼트(3개) 팁에서 나사산 5개 위치에 O링(부품 번호 1473485-00-A)을 장착합니다.
  2. LH 전면 모터 마운트 아이솔레이터를 차체에 고정하는 새 볼트를 손으로 조입니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    볼트 O링이 절연체 마운트에 끼이면 마운팅 볼트 3개에서 O링을 탈거하고 볼트를 마운트에 끼운 다음 O링을 다시 장착합니다.
  3. LH 전면 모터 마운트 아이솔레이터를 차체에 고정하는 새 볼트(3개)를 조입니다.
    62 Nm (45.7 lbs-ft)
  4. 전면 서브프레임 어셈블리를 차량에 장착합니다. 참조 항목: Subframe Assembly - Front (Dual Motor) (Remove and Install).
  5. 서브프레임을 탈거하고 다시 장착한 후: Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.