NVH Pad - Glove Box (Remove and Replace)
Correction code
14051302
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 전면 도어를 엽니다.
- LH 및 RH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 에어 웨이브 베젤 캡을 탈거합니다. End Cap - Air Wave - LH (Remove and Replace)을(를) 참조하십시오.
- 주 계기판 장식 트림을 탈거합니다. Decor Trim - Instrument Panel - Main (Remove and Replace)을(를) 참조하십시오.
- LH 중간 A필러 트림을 탈거합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
- LH 하단 A필러 트림을 탈거합니다. Trim - A-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
- 글로브박스를 탈거합니다. Glove Box - Without Knee Airbags (Remove and Replace)을(를) 참조하십시오.
-
글로브 박스에서 NVH 패드를 벗겨냅니다.
- IPA 천을 사용하여 글로브박스에서 남은 접착제 잔여물을 제거한 다음 IPA가 건조되도록 1분간 기다립니다.
-
글로브 박스 어셈블리에 새 NVH 패드를 장착합니다.
- 글로브박스를 장착합니다. Glove Box - Without Knee Airbags (Remove and Replace)을(를) 참조하십시오.
- LH 하단 A필러 트림을 장착합니다. Trim - A-Pillar - Lower - LH (Remove and Replace)을(를) 참조하십시오.
- LH 중간 A필러 트림을 장착합니다. Trim - A-Pillar - Middle - LH (Remove and Replace)을(를) 참조하십시오.
- 주 계기판 장식 트림을 장착합니다. Decor Trim - Instrument Panel - Main (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 에어 웨이브 베젤 캡을 장착합니다. End Cap - Air Wave - LH (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 계기판 엔드캡을 장착합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
- 전면 도어를 닫습니다.