2025-09-23

Handle - Exterior Release - Door - Rear - LH (Remove and Replace)

Correction code 11452002 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and their components.

Remove

  1. LH 후면 도어 트림 패널을 탈거합니다. 참조 항목: Panel - Door Trim - Rear - LH (Remove and Install).
  2. 후면 LH 도어 글라스를 탈거합니다. 참조 항목: Glass - Door - LH - Rear (Remove and Replace).
  3. LH 후면 창문 모터/조절기 어셈블리를 탈거합니다. 참조 항목: 창문 조절기 - 후면 - LH(탈거 및 교체).
  4. LH 후면 도어 외측 해제 핸들에서 전기 커넥터를 연결 해제합니다.
  5. LH 후면 도어 외부 해제 핸들 너트에 접근하는 플러그(2개)를 탈거합니다.
  6. LH 후면 도어 외부 해제 핸들을 도어에 고정하는 너트를 탈거한 다음 도어에서 핸들을 탈거합니다.
    7 Nm (5.2 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    나이록 너트를 교체하지 않습니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10mm 소켓

Install

Installation procedure is the reverse of removal, except for the following:

  • 새 핸들을 장착하거나 탈거한 핸들을 새 도어에 장착한 경우 핸들을 조정하십시오.