Wiper Blades (Remove and Replace)
Correction code
양쪽:
17501702
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
, LH:
17500402
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
, RH:
17500502
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 터치스크린에서 로 이동하여 "와이퍼 정비 모드"를 켭니다.
- 타월 또는 작업용 걸레를 와이퍼 암 아래에 배치하여 윈드실드에 흠집을 방지합니다.
-
LH 와이퍼 블레이드를 LH 와이퍼 암에 고정하는 탭을 푼 다음 차량에서 LH 와이퍼 블레이드를 탈거합니다.
- RH 와이퍼 블레이드를 RH 와이퍼 암에 고정하는 탭을 분리한 다음 차량에서 RH 와이퍼 블레이드를 탈거합니다.
Install
- 새 RH 와이퍼 블레이드를 고정 탭이 보이고 딸깍 소리가 들릴 때까지 RH 와이퍼 암에 장착합니다.
- 새 LH 와이퍼 블레이드를 고정 탭이 보이고 딸깍 소리가 들릴 때까지 LH 와이퍼 암에 장착합니다.
- 타월 또는 작업용 걸레를 윈드실드에서 제거합니다.
- 터치스크린에서 로 이동하여 "와이퍼 정비 모드"를 끕니다.