2020-12-16

Light - Turn Signal / Fog - Front - LH (Remove and Replace)

Correction code 17404002 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Light - Turn Signal / Fog - Front - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
LH 전면 방향 지시등/안개등을 전면 페시아에 고정하는 볼트
2.8 Nm (2.1 lbs-ft)
  • Torx T25 소켓
  • 4인치 익스텐션
Reuse

Remove

  1. LH 전륜 휠을 탈거합니다. Wheel Assembly (Remove and Install)을(를) 참조하십시오.
  2. 차량에 LH 전륜 휠 아치 라이너를 고정하는 클립(9개)을 분리한 후, 아래의 단계를 진행하기 위해 휠 아치 라이너를 옆으로 옮깁니다.
  3. LH 전면 방향지시등/안개등에서 전기 커넥터를 연결 해제합니다.
  4. 페시아 전기 하네스를 LH 전면 방향 지시등/안개등에 고정하는 클립을 분리합니다.
  5. 나사를 탈거한 다음 LH 전면 방향 지시등/안개등을 전면 페시아에 고정하는 탭을 분리합니다.
    2.8 Nm (2.1 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • Torx T25 소켓
    • 4인치 익스텐션
  6. 차량에서 LH 전면 방향 지시등/안개등을 탈거합니다.

Install

Installation procedure is the reverse of removal.

모든 부품을 다시 장착한 후 전면 안개등을 규격에 맞게 조정합니다. Light - Fog - Front (Adjust)을(를) 참조하십시오.