2025-06-27

Panel - Aero Shield - Rear (Remove and Replace)

Correction code 12030502 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2024-01-04: 소모품 정보를 업데이트했습니다.

Torque Specifications

표 1. Torque Specifications: Panel - Aero Shield - Rear (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
후면 에어로 실드 패널을 차량에 고정하는 볼트
5.5 Nm (4.1 lbs-ft)
  • 10mm 소켓
  • 4인치 익스텐션
  • 래칫/토크 렌치
Reuse
Informational PurposesAn informational icon, calling your attention
참고
장착 전에 나사 고정제를 각 볼트의 나사산에 도포합니다.

Remove

  1. 차량을 올려서 지탱합니다. Raise Vehicle - 2 Post Lift을(를) 참조하십시오.
  2. 후면 에어로 실드 패널을 차량에 고정하는 볼트(13개)를 탈거한 다음, 차량에서 패널을 탈거합니다.
  3. HV 배터리 뒤쪽의 HV 배터리 벤트 어셈블리를 검사하여 브리더가 있는지 확인합니다.
  4. 브리더가 없는 경우, 장착합니다. Breathers - HV Battery (Remove and Replace)을(를) 참조하십시오.
    Informational PurposesAn informational icon, calling your attention
    참고
    브리더를 장착한 후, 필요한 경우 후면 에어로 실드 패널의 탈거를 요구하는 절차로 돌아갑니다.

Install

  1. 후면 에어로 실드 패널을 차량에 고정하는 볼트의 나사산에 나사 고정제를 얇게 도포합니다.
  2. 후면 에어로 실드 패널을 차량 하부에 장착한 다음, 패널을 차량에 고정하는 볼트를 장착합니다.
    5.5 Nm (4.1 lbs-ft)
  3. 차량을 낮춥니다. Raise Vehicle - 2 Post Lift을(를) 참조하십시오.