Seal - Perimeter - HV Battery (Remove and Replace)
Correction code 16103002 3.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
-
참고HV 배터리 주변 씰은 두 종류(구형 플래터 경계 씰 및 신형 보조 베이 경계 씰)가 있습니다. 각각 플래터 타입 및 보조 베이 타입이라고 합니다. 이 절차에서는 두 종류를 모두 제거하지만 오직 보조 베이 주변 씰만 장착합니다.
- HV 배터리를 탈거합니다. 참조 항목: HV Battery (RWD) (Remove and Install).
-
HV 배터리 주변 씰을 제거하여 폐기합니다.
참고플래터 주변 씰을 제거할 때, 씰을 접착선에서 90도 각도로 측면 쪽으로 벗겨냅니다.
그림 1. 플래터 타입 그림 2. 보조 베이 타입 -
IPA 천을 사용해 HV 배터리 커버 표면에서 접착제와 잔류물을 소제합니다.
TIp접착제 지우개 휠이 장착된 드릴을 사용해 빠르게 소제합니다.
Install
-
보조 베이 주변 씰을 HV 배터리에 장착합니다.
- HV 배터리를 장착합니다. 참조 항목: HV Battery (RWD) (Remove and Install).