Strap - 12V Battery (Remove and Replace)
Correction code
17014202
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
12V 배터리 고정 스트랩 너트 또는 볼트 |
![]() 5 Nm (3.7 lbs-ft) |
|
Reuse | 이전 차량은 스트랩 후면 근처의 너트를 사용합니다. 신형 차량은 스트랩 전면에 있는 볼트를 사용합니다. |
Remove(후면 후크가 있는 스트랩)
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
-
12V 배터리 상부 타이 다운 브래킷을 A/C 컴프레서 브래킷에 고정하는 너트를 탈거합니다.5 Nm (3.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10mm 딥소켓
- ¼인치 표준 래칫
- 배터리 스트랩을 위로 들고 후면 타이 다운 스트랩에서 후크를 해제한 다음 스트랩을 차량에서 탈거합니다.
Remove(전면 후크가 있는 스트랩)
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
-
12V 배터리 상부 타이 다운 브래킷을 12V 배터리 스트랩에 고정하는 너트를 풀어줍니다.5 Nm (3.7 lbs-ft)TIpUse of the following tool(s) is recommended:
- 10mm 딥소켓
- ¼인치 표준 래칫
-
12V 배터리 스트랩을 누르고 오른쪽으로 밀어 전면 후크 및 후면 타이 다운 어셈블리에서 분리합니다.
-
차량에서 12V 배터리 스트랩을 탈거합니다.
Install
Installation procedure is the reverse of removal.