플레넘 - 인입 - HVAC(탈거 및 교체)
Correction code
18109102
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
-
HVAC 인입 플레넘을 내측 HVAC 플레넘 덕트에 고정하는 클립을 푼 다음 차량에서 HVAC 인입 플레넘을 탈거합니다.
Install
Installation procedure is the reverse of removal, except for the following:
- 클립을 고정하기 전에 HVAC 인입 플레넘 하단의 탭을 정렬합니다.