2024-09-09

Seal - Trunk (Remove and Replace)

Correction code 11702002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

  1. 트렁크 실 트림을 탈거합니다. 참조 항목: Trim - Sill - Trunk (Remove and Replace).
  2. 트렁크 씰을 트렁크 주변에서 분리한 다음 차체에서 실을 탈거합니다.

Install

  1. 트렁크 씰의 선을 스트라이커와 정렬합니다.
  2. 트렁크 씰을 트렁크 주변에 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    트렁크 씰을 고무 해머로 가볍게 두드리고 플라스틱 트림 공구를 사용하여 트렁크 씰을 차체에 완전히 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    씰의 아래쪽을 후면 페시아에 밀어 넣어야 합니다.
  3. 트렁크 실 트림을 장착합니다. Trim - Sill - Trunk (Remove and Replace)을(를) 참조하십시오.
  4. 트렁크 씰의 스트링을 당겨 내부에 편평하게 안착되게 합니다.
  5. 후면 트렁크 플로어를 장착합니다.
  6. 트렁크를 닫습니다.