2023-12-26

Foam - Cushion - Driver Seat (Remove and Replace)

Correction code 13070102 0.66 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Seat base edges are sharp and can cause personal injury. Wear cut resistant gloves when removing the seat from the vehicle, and while performing procedures that involve work on or near the seat base.

Install

  1. 새 승객 감지 센서를 새 시트 쿠션 폼 패드에 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    접착 보호대를 제거한 다음 폼 패드의 표시 사이에 승객 감지 센서를 고정합니다.
  2. 승객 감지 센서 커넥터를 폼 패드를 통해 배치한 다음 플라스틱 케이스를 커넥터 하네스에 장착합니다.
  3. 시트 쿠션 히터 매트를 시트 쿠션 폼 패드에 장착합니다.
  4. 운전석 시트 쿠션 트림을 장착합니다. 참조하십시오. Trim - Cushion - Driver Seat (Remove and Replace)