Sensor - Radar - Front (Remove and Replace)
Correction code
17201502
0.72
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 전면 페시아를 탈거합니다. Fascia - Front (Remove and Install)을(를) 참조하십시오.
-
전면 레이더 센서 배선 하네스를 전면 엔드 캐리어에 고정하는 클립을 분리합니다.
-
레이더 센서에서 전기 커넥터 하네스를 연결 해제합니다.
-
레이더 센서를 전면 레이더 센서 브래킷에 고정하는 클립을 분리한 다음 차량에서 센서를 탈거합니다.
Install
-
전면 레이더 센서를 브래킷에 장착합니다.
-
전면 레이더 센서 전기 커넥터를 연결합니다.
-
전면 레이더 센서 배선 하네스를 전면 엔드 캐리어 클립에 연결합니다.
- 전면 페시아를 장착합니다. Fascia - Front (Remove and Install)을(를) 참조하십시오.
- Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
- 전면 레이더 센서 보정 절차를 수행합니다. Sensor - Radar - Front (Calibration)을(를) 참조하십시오.