2022-10-23

ECU - Headlight - LH (Remove and Replace)

Correction code 17400812 0.65 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 차량을 들어 올려서 지지합니다. Raise Vehicle - 2 Post Lift을(를) 참조하십시오.
  2. 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  3. LH 및 RH 전륜 휠을 탈거합니다. Wheel Assembly (Remove and Install)을(를) 참조하십시오.
  4. 전면 페시아를 탈거합니다. Fascia - Front (Remove and Install)을(를) 참조하십시오.
  5. LH 헤드라이트 어셈블리를 탈거합니다. Headlight - LH (Remove and Replace)을(를) 참조하십시오.
  6. 헤드라이트 ECU를 LH 헤드라이트 어셈블리에 고정하는 나사(3개)를 탈거합니다.
  7. 헤드라이트 ECU를 LH 헤드라이트 어셈블리에 연결하는 전기 커넥터를 분리한 다음 LH 헤드라이트 어셈블리에서 헤드라이트 ECU를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    필요한 경우 헤드라이트 어셈블리에서 씰을 제거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    잠금 탭을 분리한 다음 일자 드라이버로 전기 커넥터를 들어 올립니다.

Install

  1. LH 헤드라이트 ECU 커넥터를 연결한 다음 ECU를 헤드라이트에 배치합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    필요한 경우 씰을 헤드라이트에 배치합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    전기 커넥터를 헤드라이트 ECU에 정렬한 다음 커넥터를 헤드라이트 ECU로 미는 동안 잠금 탭을 잠급니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    전기 커넥터 및 잠금 탭이 완전히 안착했는지 확인합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    헤드라이트 ECU를 아래쪽으로 누른 다음 회전하여 패스너 구멍 및 회전 방지 가이드를 정렬합니다.
  2. 헤드라이트 ECU를 LH 헤드라이트 어셈블리에 고정하는 나사(3개)를 장착합니다.
    2 Nm (1.5 lbs-ft)
  3. LH 헤드라이트 어셈블리를 장착합니다. Headlight - LH (Remove and Replace)을(를) 참조하십시오.
  4. 전면 페시아를 장착합니다. Fascia - Front (Remove and Install)을(를) 참조하십시오.
  5. LH 및 RH 전륜 휠을 장착합니다. Wheel Assembly (Remove and Install)을(를) 참조하십시오.
  6. Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
  7. 후드 내 보관 유닛을 장착합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  8. 실내 흡기 덕트를 장착합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
  9. 후면 후드 내 에이프런을 장착합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  10. 헤드라이트를 조정합니다.