2024-09-09

Light - Side Repeater - Front - LH (Remove and Replace)

Correction code 17403002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-12-12: 루틴을 업데이트했습니다.
그림 1. Model 3에서 본 모습, Model Y도 유사함
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.

Remove

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Whenever a camera has been moved out of its original position (for example, a camera or windshield replacement), camera calibration data must be cleared using the vehicle touchscreen: Controls > Service > Camera Calibration > Clear Calibration.
  1. LH 전면 도어를 열고 LH 전면 창문을 내립니다.
  2. 터치스크린을 사용하여 정비 모드를 활성화합니다. 참조 항목: Service Mode.
  3. LH 전면 사이드 리피터등 주변의 LH 전면 펜더에 보호 테이프를 부착합니다.
  4. LH 전면 사이드 리피터등의 하부에서 리피터등을 LH 전면 펜더에 고정하는 클립(2개)을 분리한 다음 펜더에서 리피터등을 분리합니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    동일한 사이드 리피터를 다시 장착하는 경우 마운팅 탭이 손상되지 않도록 주의합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    사이드 리피터를 위쪽으로 조심스럽게 들어올려 하부를 빼내 펜더에서 분리합니다. 클립 개수는 다를 수 있습니다.
  5. LH 전면 사이드 리피터등 커넥터(2개)에서 전기 하네스를 연결 해제한 다음 차량에서 리피터등을 탈거합니다.

Install

  1. 전기 하네스를 LH 전면 사이드 리피터등 커넥터(2개)에 연결합니다.
  2. LH 전면 사이드 리피터등을 LH 전면 펜더에 단단히 장착한 다음 리피터등을 펜더에 고정하는 클립을 조입니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    동일한 쪽 리피터를 다시 장착하는 경우 마운팅 탭과 클립이 손상되지 않았는지 확인하십시오. 탭이나 클립이 손상된 경우 리피터를 교체합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    클립 개수는 다를 수 있습니다.
  3. LH 전면 사이드 리피터등 주변의 LH 펜더에서 보호 테이프를 제거합니다.
  4. 터치스크린에서차량 정보 > 드라이버 어시스트 > 카메라 > DAS 초기화를 탭한 다음, 메시지에 따라 루틴을 실행합니다.
  5. 정비 모드를 종료합니다. 참조 항목: Service Mode.
  6. LH 전면 창문을 올리고 LH 전면 도어를 닫습니다.
  7. 이제 카메라 자체 보정을 하게 하려면 수동 주행이 필요하다고 고객에게 알려줍니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    Self-calibration can take up to 100 miles (160 km) of manual driving, depending upon the road type and condition. Until self-calibration is complete, the message "Autopilot Features Currently Unavailable: Manual Driving Required While Camera Is Calibrating" is displayed if an attempt is made to engage an Autopilot feature.