2025-01-03

ECU - Charge Port (Remove and Replace)

Correction code 44015002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 모든 도어를 열고 창문을 내립니다.
  2. 트렁크를 엽니다.
  3. 운전석 시트 및 전면 동승석 시트를 완전히 앞으로 이동합니다.
  4. 12V/LV 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
  5. 트렁크 가니시를 탈거합니다. 참조 항목: Garnish - Trunk (Remove and Replace).
  6. 트렁크 플로어 트림을 탈거합니다. 참조 항목: Trim - Floor - Trunk (Remove and Replace).
  7. 트렁크 실 트림 패널을 탈거합니다. 참조 항목: Trim - Sill - Trunk (Remove and Replace).
  8. LH 트렁크 사이드 트림의 후면을 차량에 고정하는 푸시 클립(3개)을 분리합니다.
  9. 퍼들 램프에서 전기 커넥터를 연결 해제합니다.
  10. 트렁크 카펫에서 LH 트렁크 사이드 트림을 분리하고 충전 포트 ECU에 접근할 수 있도록 트림을 뒤로 당긴 다음 카펫을 트림에 끼워 넣습니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    과도한 구김을 방지하기 위해 트림을 조심스럽게 배치합니다.
  11. 충전 포트 ECU에서 전기 커넥터 3개를 연결 해제합니다.
  12. 충전 포트 ECU를 차체에 고정하는 볼트를 탈거합니다.
    5.5 Nm (4.1 lbs-ft)
  13. 충전 포트 ECU를 밀어 ECU를 차체에 고정하는 탭(2개)을 분리한 다음 차량에서 ECU를 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

  • Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.
    Informational PurposesAn informational icon, calling your attention
    참고
    새 ECU를 장착하면 지연으로 인해 12V/LV 배터리가 과도하게 소모될 수 있으므로 소프트웨어 재설치를 즉시 시작하십시오.