2020-12-16

Sill Plate - Front - LH (Remove and Replace)

Correction code 12051102 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1049517-00-A 심 롤러, 실리콘, 5"

Remove

  1. LH 전면 도어를 엽니다.
  2. IPA 와이프를 사용하여 씰 플레이트 주위를 소제합니다.
  3. 실 플레이트 주변에 마스킹 테이프를 부착하여 장착 위치를 표시합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    테이프를 실 플레이트 주위에 최대한 가깝게 배치합니다.
  4. 플라스틱 트림 공구를 사용하여 실 플레이트를 조심스럽게 들어 올려 구부립니다.
  5. 플라이어를 사용하여 실 플레이트를 위로 당기는 동안 접이식 날을 사용하여 접착제를 자릅니다.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    신체 상해 위험을 줄이기 위해서 이 작업 수행 시 절단 방지 장갑을 착용하십시오.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    차량 트림 또는 차체가 손상되지 않도록 주의하십시오.
  6. IPA 와이프를 사용하여 남은 접착제를 닦아냅니다.

Install

  1. 새 실 플레이트 접착 뒷면을 제거합니다.
  2. 마스킹 테이프를 가이드로 사용하여 새 실 플레이트를 조심스럽게 제자리에 놓고 아래로 눌러 차량에 부착합니다.
  3. 심 롤러를 사용하여 접착제를 완전히 적십니다.
  4. 실 플레이트에서 보호 필름을 제거합니다.
  5. 도어 씰에서 마스킹 테이프를 제거합니다.
  6. LH 전면 도어를 닫습니다.