2025-04-11

Breather - Rear Drive Unit (Remove and Replace)

Correction code 40305402 1.38 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2025-03-31: 얼라인먼트 점검이 필요한지 여부와, 필요한 경우 어떤 종류의 얼라인먼트 점검이 필요한지에 대해 정의하는 서스펜션 얼라인먼트 표를 참조하는 단계를 추가했습니다.

Install

  1. 후륜 구동 장치에 브리더를 장착합니다.
    5 Nm (3.7 lbs-ft)
  2. 후면 서브프레임 어셈블리를 장착합니다. 참조 항목: Subframe Assembly - Rear (Remove and Install).
  3. 서브프레임을 탈거하고 다시 장착한 후: Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.