2021-12-26

Airbag - Front Passenger (Remove and Install)

Correction code 20010301 1.98 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see 에어백 및 안전보조장치(SRS) 사전 주의 사항.
Warning IconA warning icon, calling your attention to a possibly risky situation
경고
안전보조장치(SRS) 구성품을 올바르게 취급하지 않으면 위험할 수 있습니다. 에어백 및 안전보조장치(SRS) 사전 주의 사항을(를) 참조하십시오.

Remove

  1. IP 캐리어를 탈거합니다. IP Carrier (Remove and Install)을(를) 참조하십시오.
  2. 에어백 어셈블리의 전면 가장자리를 따라 압력을 가하는 동안 IP 동승석 에어백 주변을 구부려서 IP 캐리어 주변에서 각 에어백 탭 6개를 분리합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    대형 일자 스크루드라이버를 사용하여 탭 분리를 돕습니다.
  3. 에어백을 위쪽으로 돌려 IP 캐리어 주변에서 에어백 후면의 탭 7개를 잠금 해제한 다음 IP 캐리어에서 에어백을 탈거합니다.

Install

  1. 에어백 후면의 탭 7개를 IP 캐리어 주변의 일치하는 개구부에 삽입합니다.
  2. 에어백 전면의 탭 6개가 제자리에 고정될 때까지 에어백을 돌려 IP 캐리어에 끼웁니다.
  3. IP 캐리어를 장착합니다. IP Carrier (Remove and Install)을(를) 참조하십시오.