2019-08-13

Pipes - Refrigerant - High / Low Pressure (Non-Heat Pump) (Remove and Replace)

Correction code 18204802 1.68 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. A/C 냉매를 회수합니다. A/C Refrigerant (Recovery and Recharge)을(를) 참조하십시오.
    Informational PurposesAn informational icon, calling your attention
    참고
    이 절차를 수행하기 전에 냉매를 완전히 회수하십시오.
  2. 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
  3. 전면 페시아 밸런스를 탈거합니다. Valance - Front Fascia (Remove and Replace)을(를) 참조하십시오.
  4. A/C 인입 라인을 콘덴서 팬 모듈에 고정하는 너트를 탈거한 다음 라인을 탈거합니다.
    22 Nm (16.2 lbs-ft)
  5. 외측 플레넘을 내측 플레넘에 고정하는 클립을 분리하고 외측 플레넘을 탈거합니다.
  6. 내측 플레넘을 HVAC 어셈블리에 고정하는 너트를 탈거하고 플레넘을 탈거합니다.
  7. 액체 라인을 TXV에 고정하는 너트를 탈거하고 TXV에서 라인을 탈거합니다.
    22 Nm (16.2 lbs-ft)
  8. 액체 라인을 컴프레서에 고정하는 너트를 탈거하고 컴프레서에서 라인을 탈거합니다.
    22 Nm (16.2 lbs-ft)
  9. 저압 변환기에서 하네스 커넥터를 연결 해제합니다.
  10. 라인을 슈퍼보틀에 고정하는 클립을 분리합니다.
  11. 라인을 쇼크 타워 브레이스에 고정하는 볼트를 탈거합니다.
    5.5 Nm (4.1 lbs-ft)
  12. 액체 라인을 EXV 냉각 장치 어셈블리에 고정하는 볼트를 탈거하고 EXV에서 라인을 탈거합니다.
    22 Nm (16.2 lbs-ft)
  13. 차량에서 라인을 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following: