2024-02-16

EPAS Alignment Check

Correction code 31001500 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
This procedure is a DRAFT. Although it has been validated, Warnings and Cautions might be missing. Follow safety requirements and use extreme caution when working on or near High Voltage systems and components.
Informational PurposesAn informational icon, calling your attention
참고
This procedure assumes the vehicle suspension is operating as intended. If needed, a vehicle general inspection can be performed.

절차

  1. LH 전면 도어를 열고 LH 전면 창문을 내립니다.
  2. 차량을 정비 모드로 설정합니다. 참조 항목: Service Mode.
  3. 차량 게이트웨이를 잠금 해제합니다. 참조 항목: 게이트웨이(잠금 해제).
  4. 터치스크린에서 "Speed Limit"를 비활성화합니다. Service > Service Settings > Remove Speed Limit를 터치합니다.
  5. 정렬 포털로 이동합니다. Service > Chassis > Alignment and Tires를 터치합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    드라이브 레일이 켜져 있는지 확인하십시오.
  6. 차량을 500m 정도의 공간이 있는 평평한 곳으로 옮깁니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    테스트를 완료하려면 차량이 500m 이내에서 30km/h(18mph)를 초과해야 합니다.
  7. Service > Chassis > Alignment and Tires > Offset Drive Test > Run을 터치한 다음 최소 30km/h(18mph)의 속도로 차량을 직선으로 500m 주행합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    스티어링 요크/휠을 200도 이상 돌리면 테스트가 종료될 수 있습니다.
  8. 테스트를 완료한 후에는 차량을 멈춰 테스트 결과를 확인합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    테스트 결과를 보려면 Offset Drive Test를 터치해야 할 수 있습니다.
    그림 1. 오프셋 드라이브 테스트 결과
    • 테스트를 통과한 경우: 4휠 얼라인먼트가 필요하지 않습니다. 9단계로 건너뜁니다.
    • 테스트에 실패한 경우: 차량에 4휠 얼라인먼트 점검 및 조정이 필요합니다. 참조 항목: Four Wheel Alignment Check and Adjust.
  9. 정비 모드를 비활성화합니다. 참조 항목: Service Mode.
  10. LH 전면 창문을 올리고 LH 전면 도어를 닫습니다.