2022-10-31

Sensor - Impact Accelerometer - Front Bumper - Center (Remove and Replace)

Correction code 20203302 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see 에어백 및 안전보조장치(SRS) 사전 주의 사항.

Torque Specifications

표 1. Torque Specifications: Sensor - Impact Accelerometer - Front Bumper - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
에어백 센서를 전면 종단부 캐리어에 고정하는 볼트
10 Nm (7.4 lbs-ft)
  • 10mm 딥소켓
  • ¼인치 표준 플렉스 헤드 래칫
  • ¼인치 플렉스 헤드 토크 렌치(장착 전용)
Reuse

Remove

  1. 모든 도어를 엽니다.
  2. 모든 창문을 내립니다.
  3. 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
  4. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  5. 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
  6. 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
  7. 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  8. 중앙 전면 에어백 센서에서 전기 배선 하네스 커넥터를 연결 해제합니다.
  9. 중앙 전면 에어백 센서를 차체에 고정하는 볼트를 탈거한 다음 차체에서 센서를 탈거합니다.
    10 Nm (7.4 lbs-ft)

Install

Installation procedure is the reverse of removal.