Accelerator (Remove and Replace)
Correction code
17551002
0.48
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 2열 하단 시트 쿠션을 탈거합니다. 참조 항목: Seat Cushion - Lower - 2nd Row (Remove and Replace).
- 후면 후드 내 에이프런을 탈거합니다. 참조 항목: Underhood Apron - Rear (Remove and Replace).
- 12V/LV 전원을 연결 해제합니다. 참조 항목: 12V/LV Power (Disconnect and Connect).
- 운전석 무릎 에어백을 탈거합니다. 참조 항목: Airbag - Knee - Driver (Remove and Install).
- LH 발밑 공간 덕트를 탈거합니다. 참조 항목: Duct - Footwell - LH (LHD) (Remove and Replace).
-
가속 페달에서 전기 커넥터를 연결 해제합니다.
경고커넥터 잠금 탭이 빨간색인 경우 빨간색 잠금 탭을 페달 하우징에서 당겨 빼냅니다.
-
가속 페달을 차체에 고정하는 볼트를 탈거합니다.
- 가속 페달을 아래쪽으로 민 다음 차량에서 가속 페달을 탈거합니다.
Install
- 가속 페달을 위쪽으로 민 다음 가속 페달을 브래킷에 장착합니다.
-
가속 페달을 차체에 고정하는 볼트를 장착합니다.7 Nm (5.2 lbs-ft)
-
가속 페달 전기 커넥터를 연결합니다.
참고커넥터 잠금 탭이 빨간색인 경우: 빨간색 잠금 탭을 페달 하우징 쪽으로 누릅니다.
- LH 발밑 공간 덕트를 장착합니다. 참조 항목: Duct - Footwell - LH (LHD) (Remove and Replace).
- 운전석 무릎 에어백을 장착합니다. 참조 항목: Airbag - Knee - Driver (Remove and Install).
- 12V/LV 전원을 다시 연결합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
- Toolbox 3이 설치된 노트북을 차량에 연결합니다.
- 다음 Toolbox 루틴을 실행하여 페달 작동을 확인합니다.
- 후면 후드 내 에이프런을 장착합니다. 참조 항목: Underhood Apron - Rear (Remove and Replace).
- 2열 하단 시트 쿠션을 장착합니다. 참조 항목: Seat Cushion - Lower - 2nd Row (Remove and Replace).