2021-07-23

Hinge - Hood - LH (Remove and Replace)

Correction code 11330302 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  2. 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
  3. 후드 래치 커버를 탈거합니다. Cover - Hood Latch (Remove and Replace)을(를) 참조하십시오.
  4. 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  5. LH 및 RH 와이퍼 암을 탈거합니다. Wiper Arms (Remove and Replace)을(를) 참조하십시오.
  6. LH 및 RH 쇼크 타워 커버를 탈거합니다. Cover - Shock Tower - LH (Remove and Replace)을(를) 참조하십시오.
  7. LH 및 RH 후드 힌지 커버를 후드 힌지에 고정하는 클립을 분리한 다음 LH 및 RH 후드 힌지 커버를 탈거합니다.

    LH 후드 힌지 커버를 표시했으며 RH도 유사함

  8. 카울 스크린 패널을 탈거합니다. Panel - Cowl Screen (Remove and Replace)을(를) 참조하십시오.
  9. LH 후드 힌지를 교체하는 경우 와이퍼 모터를 탈거합니다. Wiper Module (Remove and Replace)을(를) 참조하십시오.
  10. 후드를 개방 위치에서 지지합니다.
  11. LH 및 RH 후드 가스 스트럿을 탈거합니다. Gas Strut - Hood - LH (Remove and Replace)을(를) 참조하십시오.
  12. 마스킹 테이프를 사용하여 후드와 연결된 RH 및 LH 후드 힌지의 위치를 표시합니다.
  13. 보조 작업자의 도움을 받아 차량에서 후드 지지대를 탈거합니다.
  14. 후드를 탈거합니다. Hood (Remove and Install)을(를) 참조하십시오.
  15. 테이프를 사용하여 차체의 힌지 장착 위치를 표시합니다.
  16. LH 후드 힌지를 차체에 고정하는 볼트를 분리한 다음 차량에서 힌지를 탈거합니다.
    24 Nm (17.7 lbs-ft)

    LH 후드 힌지를 표시했으며 RH도 유사함

Install

Installation procedure is the reverse of removal.