Striker - Seat Back - 2nd Row - RH (Remove and Replace)
Correction code
13056402
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 2열 시트 사이드 볼스터를 탈거합니다. Bolster - Side - Seat - 2nd Row - LH (Remove and Replace)을(를) 참조하십시오.
- LH 사이드 레일 트림을 탈거합니다. Trim - Side Rail - LH (Remove and Replace)을(를) 참조하십시오.
- LH 상단 C필러 트림을 탈거합니다. Trim - C-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
- RH 사이드 레일 트림을 탈거합니다. Trim - Side Rail - LH (Remove and Replace)을(를) 참조하십시오.
- RH 상단 C필러 트림을 탈거합니다. Trim - C-Pillar - Upper - LH (Remove and Replace)을(를) 참조하십시오.
-
패키지 트레이 전면을 차체에 고정하는 클립(4개)을 분리합니다.
-
패키지 트레이를 앞으로 당긴 다음, 패키지 트레이를 들어 올려 시트 등받이 스트라이커에 접근합니다.
참고패키지 트레이를 위로 올린 상태에서 지지해 둡니다.
-
2열 RH 시트 등받이 스트라이커를 차체에 고정하는 볼트를 분리한 다음 차량에서 스트라이커를 탈거합니다.16 Nm (11.8 lbs-ft)
Install
Installation procedure is the reverse of removal.