2020-12-16

Latch - Trunk (Remove and Replace)

Correction code 11355002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Latch - Trunk (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
트렁크 래치를 트렁크 리드에 고정하는 볼트
8 Nm (5.9 lbs-ft)
  • 10mm 소켓
재사용

Remove

  1. 트렁크 리드 트림을 탈거합니다. Trim - Lid - Trunk (Remove and Replace)을(를) 참조하십시오.
  2. 래치에서 전기 커넥터를 연결 해제합니다.
  3. 래치를 트렁크 리드에 고정하는 볼트를 탈거한 다음 차량에서 래치를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • 10mm 소켓

Install

  1. 래치를 배치하고, 트렁크 리드에 래치를 고정하는 볼트를 느슨하게 장착합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • 10mm 소켓
  2. 전기 커넥터를 래치에 연결합니다.
  3. 트렁크를 닫아 간격/단차를 점검하고 필요한 경우 조정합니다.
  4. 트렁크를 열고 토크로 트렁크 리드에 래치를 장착하는 볼트를 조입니다.
    8 Nm (5.9 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    참고
    Use of the following tool(s) is recommended:
    • 10mm 소켓
  5. 트렁크 리드 트림을 장착합니다. Trim - Lid - Trunk (Remove and Replace)을(를) 참조하십시오.