USB Hub - Center Console - Front (2.0) (Remove and Replace)
Correction code
21260412
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 2023-06-20: 픽 공구로 슬롯을 통해 클립을 분리하는 단계를 추가했습니다.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
USB 허브를 센터 콘솔에 고정하는 나사 |
![]() 1.1 Nm (.8 lbs-ft) |
|
Reuse |
Remove
-
센터콘솔의 슬라이드식 보관함 뚜껑을 엽니다.
-
픽 공구로 슬롯을 통해 클립(2개)을 분리한 다음 USB 허브 하단을 센터 콘솔에 고정하는 나머지 클립(3개)을 분리합니다.
-
USB 허브 커넥터(2개)에서 전기 하네스를 연결 해제한 다음 센터 콘솔에서 USB 허브를 탈거합니다.
-
USB 허브를 USB 패널에 고정하는 나사(3개)를 탈거한 다음 패널에서 허브를 탈거합니다.
TIpUse of the following tool(s) is recommended:
- Torx T20 소켓
Install
-
USB 허브를 USB 패널에 장착한 다음 허브를 패널에 고정하는 나사를 장착합니다.1.1 Nm (.8 lbs-ft)TIpUse of the following tool(s) is recommended:
- Torx T20 소켓
-
USB 허브를 센터 콘솔 보관함에 배치한 다음 전기 하네스를 USB 허브 커넥터(2개)에 연결합니다.
-
USB 허브를 센터 콘솔 후면으로 이동한 다음 USB 허브를 센터 콘솔 후면에 고정하는 클립(5개)을 조입니다.
-
센터 콘솔의 보관함 뚜껑을 닫습니다.