Cover - Latch - Power Trunk (Remove and Replace)
Correction code
15110102
0.06
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 파워 트렁크 리드 트림을 탈거합니다. Trim - Lid - Power Trunk (Remove and Replace)을(를) 참조하십시오.
-
그림처럼 래치와 래치 커버 사이에 작은 일자 드라이버를 삽입한 후 래치에서 래치 커버를 부드럽게 들어 올립니다.
Install
Installation procedure is the reverse of removal.