Busbar - DCDC Ground (Remove and Replace)
Correction code
17102402
0.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
-
DCDC 접지 버스바를DCDC 패스스루의 HV 배터리에 고정하는 너트를 탈거하여 폐기합니다.
-
DCDC 접지 버스바를 차체에 고정하는 볼트를 탈거하여 차량에서 DCDC 접지 버스바를 탈거합니다.
Install
- IPA(이소프로필알코올) 헝겊을 사용하여 DCDC 접지 버스바와 DCDC 패스스루의 접합면을 소제합니다.
-
DCDC 패스스루의 접지 단자에 DCDC 접지 버스바를 장착한 후, DCDC 패스스루에 DCDC 접지 버스바를 고정하는 새 너트를 손으로 조입니다.
-
차체에 DCDC 접지 버스바를 고정하는 볼트를 장착하고 토크로 조인 후 페인트 펜으로 볼트를 표시합니다.20 Nm (14.7 lbs-ft)
-
DCDC 패스스루에 DCDC 접지 버스바를 고정하는 너트를 조이고, 토크로 조인 후에는 페인트 펜으로 너트를 표시합니다.15 Nm (11.1 lbs-ft)
- 12V 전원을 연결합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.