2019-08-13

Harness - Door - Rear - LH (Remove and Replace)

Correction code 17102802 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Warning IconA warning icon, calling your attention to a possibly risky situation
경고
The side impact airbag deployment depends on the front door sensor's ability to detect a side impact from air pressure. Make sure that there are no uncovered holes in the front door shells. Additionally, always reinstall plugs or tape when servicing or inspecting the front doors and their components.

Remove

  1. LH 후면 도어를 엽니다.
  2. 마스킹 테이프 2조각을 후면 LH 도어 글라스 및 외측 벨트 위에 수직으로 붙여 놓습니다.
  3. LH 후면 도어 트림 패널을 탈거합니다. Panel - Door Trim - Rear - LH (Remove and Install)을(를) 참조하십시오.
  4. LH 후면 도어 내부 벨트 씰을 후면 도어에서 탈거합니다. Seal - Inner Belt - Rear Door - LH (Remove and Replace)을(를) 참조하십시오.
  5. 후면 LH 도어 글라스를 탈거합니다. Glass - Door - LH - Rear (Remove and Replace)을(를) 참조하십시오.
  6. LH 후면 윈도우 모터 레귤레이터 어셈블리를 분리합니다. 창문 조절기 - 후면 - LH(탈거 및 교체)을(를) 참조하십시오.
  7. LH 후면 도어 래치에서 전기 커넥터를 연결 해제합니다.
  8. LH 후면 도어 외측 해제 핸들에서 전기 커넥터를 연결 해제합니다.
  9. LH 후면 도어 하네스를 LH 후면 도어에 연결하는 클립을 분리합니다.
  10. 그로밋을 분리한 다음 LH 후면 도어 하네스를 내측 도어 하네스 포트를 통해 밀어줍니다.
  11. LH 후면 도어 하네스 씰을 B필러에 고정하는 탭(x4)을 분리합니다.
  12. LH 후면 도어 하네스 커넥터를 LH 차체 하네스에서 연결 해제합니다.
  13. LH 후면 도어의 전면에서 LH 후면 도어 하네스 씰을 분리합니다.
  14. 전면 내측 도어 하네스 포트를 통해 LH 후면 도어 하네스를 밀어, 차량에서 하네스를 탈거합니다.

Install

Installation procedure is the reverse of removal.