Knuckle - Suspension - Front - LH (RWD) (Remove and Replace)
Correction code
31010102
0.54
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- LH 전면 브레이크 더스트 실드를 탈거합니다. Shield - Dust - Brake - Front - LH (Remove and Replace)을(를) 참조하십시오.
-
LH 전면 ABS 휠 속도 센서 전기 하네스를 LH 전면 서스펜션 너클에 고정하는 볼트를 탈거합니다.5 Nm (3.7 lbs-ft)
-
LH 전면 ABS 휠 속도 센서 전기 하네스를 LH 전면 서스펜션 너클에 고정하는 클립을 분리합니다.
-
LH 타이로드 엔드를 LH 전면 서스펜션 너클에 고정하는 너트를 탈거하여 폐기합니다.180 Nm (132.7 lbs-ft)
- 차량에서 LH 타이로드 엔드를 탈거합니다.
-
LH 상단 컨트롤 암을 LH 전면 서스펜션 너클에 고정하는 볼트 및 너트를 탈거합니다.56 Nm (41.3 lbs-ft)56 Nm (41.3 lbs-ft)
-
LH 전면 하단 컴플라이언스 링크를 전면 서스펜션 너클에 고정하는 너트를 탈거하여 폐기합니다.180 Nm (132.7 lbs-ft)
-
LH 전면 하단 래터럴 링크를 LH 전면 서스펜션 너클에 고정하는 너트를 탈거하여 폐기합니다.180 Nm (132.7 lbs-ft)
- 차량에서 전면 서스펜션 너클 및 허브 어셈블리를 탈거합니다.
-
전면 허브를 전면 너클에 고정하는 볼트를 탈거합니다.85 Nm (62.7 lbs-ft)
-
전면 서스펜션 너클에서 전면 허브를 분리합니다.
Install
Installation procedure is the reverse of removal, except for the following:
- Replace all nyloc nuts.
- Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.