2020-12-16

End Panel - Center Console (Remove and Replace)

Correction code 15195002 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications:End Panel - Center Console (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
센터 콘솔 엔드 패널을 센터 콘솔에 고정하는 볼트
1.1 Nm (.8 lbs-ft)
  • Torx T20 소켓
  • 4인치 익스텐션
Reuse

Remove

  1. 센터콘솔 하단 후면 패널을 탈거합니다. Panel - Lower Rear - Center Console (Remove and Replace)을(를) 참조하십시오.
  2. 센터콘솔 공기 통풍구 패널을 탈거합니다. Assembly - Rear Vent - Center Console (Remove and Replace)을(를) 참조하십시오.
  3. 볼트(2개)를 탈거하고 센터콘솔 엔드 패널을 센터콘솔에 고정하는 클립(6개)을 분리한 후, 엔드 패널을 콘솔에서 탈거합니다.
    1.1 Nm (.8 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    다음 공구를 사용할 것을 권장합니다.
    • Torx T20 소켓
    • 4인치 익스텐션

Install

Installation procedure is the reverse of removal.