2019-08-13

Antenna - Bluetooth Passive Entry - Front (Remove and Replace)

Correction code 17451102 0.72 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Remove

  1. 차량을 들어 올려서 지지합니다. Raise Vehicle - 2 Post Lift을(를) 참조하십시오.
  2. 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
  3. 실내 흡기 덕트를 탈거합니다. 덕트 - 상단 - 실내 흡기(탈거 및 교체)을(를) 참조하십시오.
  4. 후드 래치 커버를 탈거합니다. Cover - Hood Latch (Remove and Replace)을(를) 참조하십시오.
  5. 후드 내 보관 유닛을 탈거합니다. Underhood Storage Unit (Remove and Replace)을(를) 참조하십시오.
  6. 전면 에어로 실드 패널을 탈거합니다. Panel - Aero Shield - Front (Remove and Replace)을(를) 참조하십시오.
  7. 전면 페시아 밸런스를 탈거합니다. Valance - Front Fascia (Remove and Replace)을(를) 참조하십시오.
  8. 전면 페시아를 탈거합니다. Fascia - Front (Remove and Install)을(를) 참조하십시오.
  9. 전면 Bluetooth 패시브 엔트리 안테나 커넥터에서 전기 커넥터를 연결 해제합니다.
  10. 전면 Bluetooth 패시브 엔트리 안테나를 전면 엔드 캐리어에 고정하는 볼트를 탈거한 다음 전면 엔드 캐리어에서 안테나를 탈거합니다.
    9 Nm (6.6 lbs-ft)

Install

Installation procedure is the reverse of removal.