2022-06-20
Duct - Air Wave - RH (RHD) (Remove and Replace)
Correction code
181081521.74
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- Remove the IP Carrier. See IP Carrier (RHD) (Remove and Replace).
-
Remove the screws (x2) that attach the RH air wave duct the to cross car beam, and
then remove the duct from the vehicle.
Install
-
Install the RH air wave duct to the
cross car beam, and then install the screws (x2) that attach the duct to the beam.2.3 Nm (1.7 lbs-ft)
- Install the IP Carrier. See IP Carrier (RHD) (Remove and Replace).