Front Upper Control Arm (FUCA) Mount - LH (Remove and Replace)
Correction code
31015002
0.78
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
- 1450399-00-A 도구, FUCA 지상고, Model 3
Remove
- 전면 상단 컨트롤 암 마운트에서 LH 전면 상단 컨트롤 암을 탈거합니다. 참조 항목: Control Arm - Upper - Front - LH (Remove and Replace).
-
전면 상단 컨트롤 암 마운트에서 LH 전면 상단 컨트롤 암 마운트 절연체를 탈거합니다.
참고재장착에 도움이 되도록 LH 전면 상단 컨트롤 암 마운트 절연체의 위치를 기록합니다.
-
전면 상단 컨트롤 암 마운트를 LH 전면 스프링 및 댐퍼 어셈블리에 고정하는 너트를 탈거합니다.
-
LH 전면 스프링 및 댐퍼 어셈블리에서 전면 상단 컨트롤 암 마운트를 탈거합니다.
Install
-
전면 상단 컨트롤 암 마운트를 LH 전면 스프링 및 댐퍼 어셈블리에 장착하고 마운트를 댐퍼 어셈블리에 고정하는 너트를 장착합니다.23 Nm (17.0 lbs-ft)
-
LH 전면 상단 컨트롤 암 마운트 절연체를 전면 상단 컨트롤 암 마운트에 장착합니다.
참고LH 전면 상단 컨트롤 암 마운트 절연체는 한 방향으로 장착됩니다.
- LH 전면 상단 컨트롤 암을 전면 상단 컨트롤 암 마운트에 장착합니다. 참조 항목: Control Arm - Upper - Front - LH (Remove and Replace).
- Refer to the Alignment Requirement tables to determine whether an EPAS alignment check (EC) or four wheel alignment check (AC) is necessary. If performed, add the alignment check/adjust correction code as a separate activity to the SV. See 얼라인먼트 요구 사항 - 서스펜션.