Brake Pads and Rotors - Rear - Set (Remove and Replace)
Correction code
33011005
0.96
NOTE: Unless
otherwise explicitly stated in the procedure, the above correction code and
FRT reflect all of the work required to perform this procedure, including
the linked procedures. Do
not stack correction codes unless explicitly told to do so.
NOTE: See Flat Rate Times to learn more about FRTs and how they are
created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make
sure wearing proper PPE when performing the below procedure.NOTE:
See 인체공학적 주의 사항for safe
and healthy working practices.
- 2025-07-01: Added correct brake burnishing step.
-
2024-05-28: Updated EPB service mode reference.
- 2023-10-16: Reorganized the procedure.
Remove
- Raise and support the vehicle. See Raise Vehicle - 2 Post Lift.
- Place the vehicle into EPB Service Mode. See Parking Brake - Caliper - Rear - LH (Release).
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Place absorbent material under the brake booster and reservoir area.
- Remove the LH and RH rear wheel caps. See Cap - Wheel (Remove and Replace).
- Remove the LH and RH rear wheels. See Wheel Assembly (Remove and Install).
- Remove the LH and RH rear brake pad kits. See Brake Pad Kit - Rear (Base Brakes) (Remove and Replace) or Brake Pad Kit - Rear (Sport Brakes) (Remove and Replace).
- Remove the LH and RH rear rotors. See Brake Rotor - Rear - LH (Remove and Replace).
Install
- Install the LH and RH rear rotors. See Brake Rotor - Rear - LH (Remove and Replace).
- Install the LH and RH rear brake pad kits. See Brake Pad Kit - Rear (Base Brakes) (Remove and Replace) or Brake Pad Kit - Rear (Sport Brakes) (Remove and Replace).
- Install the LH and RH rear wheels. See Wheel Assembly (Remove and Install).
- Install the LH and RH rear wheel caps. See Cap - Wheel (Remove and Replace).
- Put the vehicle into Park to exit EPB Service Mode and engage the parking brake.
- Repeatedly press the brake pedal until firm.
- Inspect the brake fluid level and top off as necessary.
- Remove the absorbent material from under the brake booster and reservoir area.
- Install the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Remove the vehicle from the 2 post lift. See Raise Vehicle - 2 Post Lift.
-
브레이크를 버니싱합니다. 참조 항목: Brake Pads - Burnishing.
참고차량 주행 시, 적절한 브레이크 페달의 느낌과 성능이 달성되었는지 확인하십시오.참고서비스 방문에 브레이크 패드 버니싱 교정 코드 33013000를 별도 활동으로 추가합니다.