2023-05-11

Finisher - Vent (Remove and Replace)

Correction code 14057502 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

Torque Specifications

표 1. Torque Specifications: Finisher - Vent (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
송풍구 마감재를 IP 캐리어에 고정하는 나사
2.3 Nm (1.7 lbs-ft)
  • Torx T20 소켓
  • 4인치 익스텐션
  • 래칫/토크 렌치
Reuse

Remove

  1. LH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
  2. LH 및 RH 에어웨이브 엔드캡을 모두 탈거합니다. End Cap - Air Wave - LH (Remove and Replace)을(를) 참조하십시오.
  3. 주 계기판 장식 트림을 탈거합니다. Decor Trim - Instrument Panel - Main (Remove and Replace)을(를) 참조하십시오.
  4. 통풍구 마감재의 LH 쪽을 고정하는 나사를 탈거합니다.
    2.3 Nm (1.7 lbs-ft)
  5. 통풍구 마감재의 RH 쪽을 고정하는 나사를 탈거합니다.
    2.3 Nm (1.7 lbs-ft)
  6. 통풍구 마감재를 고정하는 클립(16개)을 분리한 후, 마감재를 차량 뒤쪽으로 밀어 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    트림 공구를 삽입하려면 상단 패드가 살짝 들려야 하며, 그런 후 클립을 분리합니다.

Install

Installation procedure is the reverse of removal.