2024-10-15

Decor Trim - Instrument Panel - Main (Remove and Replace)

Correction code 14057002 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

표 1. Torque Specifications: Decor Trim - Instrument Panel - Main (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
주 장식 트림을 계기판의 LH 및 RH에 고정하는 나사
2.3 Nm (1.7 lbs-ft)
  • Torx T20 소켓
  • 4인치 익스텐션
  • 래칫/토크 렌치
Reuse

Remove

  1. LH 및 RH 계기판 엔드캡을 탈거합니다. 참조 항목: End Cap - Instrument Panel - LH (Remove and Replace).
  2. LH 및 RH 에어 웨이브 엔드캡을 탈거합니다. 참조 항목: End Cap - Air Wave - LH (Remove and Replace).
  3. 해당하는 경우 주 장식 트림을 계기판의 LH 및 RH 쪽에 고정하는 나사(2개)를 탈거합니다.
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 소켓
    • 4인치 익스텐션
    • 래칫/토크 렌치
  4. 주 계기판 장식 트림을 고정하는 클립(15개)을 분리한 다음 계기판에서 트림을 탈거합니다.

Install

  1. 주 계기판 장식 트림을 계기판에 고정하는 클립(15개)을 장착합니다.
  2. 해당하는 경우 주 장식 트림을 계기판의 LH 및 RH에 고정하는 나사(2개)를 장착합니다.
    2.3 Nm (1.7 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • Torx T20 소켓
    • 4인치 익스텐션
    • 래칫/토크 렌치
  3. LH 및 RH 에어 웨이브 엔드캡을 장착합니다. 참조 항목: End Cap - Air Wave - LH (Remove and Replace).
  4. LH 및 RH 계기판 엔드캡을 장착합니다. 참조 항목: End Cap - Instrument Panel - LH (Remove and Replace).