Radiator (Non-Heat Pump) (Remove and Replace)
Correction code
18301002
1.56
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 냉각 팬 모듈을 탈거합니다. 참조 항목: Module - Cooling Fan (Remove and Install).
-
액티브 그릴 셔터를 냉각 팬 모듈에 고정하는 클립을 분리한 다음 모듈에서 액티브 그릴 셔터를 탈거합니다.
-
라디에이터를 콘덴서 팬 모듈에 고정하는 나사를 탈거합니다.10 Nm (7.4 lbs-ft)
-
라디에이터를 콘덴서 팬 모듈에 고정하는 클립을 분리한 다음 콘덴서 팬 모듈에서 라디에이터를 탈거합니다.
Install
Installation procedure is the reverse of removal, except for the following:
- 냉각 시스템 진공 보충을 수행합니다. 참조 항목: Cooling System (Vacuum Refill).