SD Card - Car Computer (HW2.5) (Remove and Replace)
Correction code 21152402 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
- 후면 후드 내 에이프런을 탈거합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 12V 전원을 연결 해제합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
- 자동차 컴퓨터 연결 보드를 탈거합니다. Connectivity Board - Car Computer (HW2.5) (Remove and Replace)을(를) 참조하십시오.
-
트림 도구를 사용하여 SD 카드 고정 탭을 밀어 올린 다음 플라스틱 핀셋을 사용하여 컴퓨터에서 SD 카드를 탈거합니다.
경고이 그림에서 SD 카드 왼쪽에 있는 SIM 카드는 탈거하지 마십시오.
-
SD 카드 중앙을 반으로 잘라 파기한 다음 각 조각을 반으로 잘라 4조각으로 만드십시오.
경고사용자 데이터를 보호하기 위해 SD 카드를 반드시 파기해야 합니다.
Install
- 플라스틱 핀셋을 사용하여 금색 패드가 위를 향하고 벌크헤드 반대쪽을 향하도록 새 SD 카드를 컴퓨터에 장착합니다.
- 자동차 컴퓨터 연결 보드를 장착합니다. Connectivity Board - Car Computer (HW2.5) (Remove and Replace)을(를) 참조하십시오.
- 12V 전원을 연결합니다. 12V/LV Power (Disconnect and Connect)을(를) 참조하십시오.
- 후면 후드 내 에이프런을 장착합니다. Underhood Apron - Rear (Remove and Replace)을(를) 참조하십시오.
- 2열 하단 시트 쿠션을 장착합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.