ECU - Charge Port (Combo Adapter) (Retrofit)
Correction code
440151060.24
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Remove
- 기존 충전 포트 ECU를 탈거합니다. ECU - Charge Port (Remove and Replace)을(를) 참조하십시오.
Install
Installation procedure is the reverse of removal, except for the following:
-
"Native Charge Port(네이티브 충전 포트)" 값을 설정합니다.
- Toolbox에서 "Infotainment Dashboard(인포테인먼트 대시보드)"를 엽니다.
- "Vehicle Configuration(차량 구성)"을 선택합니다.
- "Read Config(구성 읽기)"를 선택한 다음 Run(실행)을 클릭합니다.
- 옵션 "plc_adapter_type"까지 스크롤을 내립니다.
- "Native Charge Port(네이티브 충전 포트)"를 선택합니다.
- "Apply Changes(변경 내용 적용)"를 선택한 다음 Run(실행)을 클릭합니다.
- Reinstall the vehicle firmware. See Software Reinstall - Touchscreen.