Vent - Front - RH (Remove and Replace)
Correction code
14053202
0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
RH 전면 송풍구를 IP 캐리어에 고정하는 나사 |
![]() 2.3 Nm (1.7 lbs-ft) |
|
Reuse |
Remove
- LH 계기판 엔드캡을 탈거합니다. End Cap - Instrument Panel - LH (Remove and Replace)을(를) 참조하십시오.
- LH 및 RH 에어 웨이브 엔드캡을 탈거합니다. End Cap - Air Wave - LH (Remove and Replace)을(를) 참조하십시오.
- 주 계기판 장식 트림을 탈거합니다. Decor Trim - Instrument Panel - Main (Remove and Replace)을(를) 참조하십시오.
- 송풍구 마감재를 탈거합니다. Finisher - Vent (Remove and Replace)을(를) 참조하십시오.
-
RH 전면 송풍구를 계기판에 고정하는 나사를 탈거한 다음, RH 전면 송풍구의 RH 쪽을 당겨 계기판에서 탈거합니다.2.3 Nm (1.7 lbs-ft)
-
RH 전면 송풍구에서 전기 커넥터를 연결 해제한 다음, RH 전면 송풍구를 차량에서 탈거합니다.
Install
Installation procedure is the reverse of removal, except for the following:
- 차량이 RHD인 경우, RH 전면 송풍구가 장착되는 공간의 폼블록을 분리하지 마십시오.