2025-06-27

Clean Radiator (Heat Pump)

Correction code 18301000 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 2023-11-02: AGS 관련 단계를 업데이트했습니다.

Procedure

  1. 차량을 2포스트 리프트에 배치합니다.
  2. LH 전면 도어를 열고 LH 전면 창문을 내립니다.
  3. 터치스크린을 사용하여 차량을 정비 모드로 설정합니다. 참조 항목:Service Mode.
  4. 액티브 그릴 셔터를 탈거합니다. Active Grille Shutter (Heat Pump) (Remove and Replace)을(를) 참조하세요.
  5. 플라스틱 그릴을 라디에이터에 고정하는 잠금 탭(8개)을 탈거합니다.
  6. 공업용 진공 청소기를 사용하여 라디에이터의 먼지를 청소합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    필요한 경우 큰 이물질을 제거합니다.
  7. 블로우 건을 사용하여 라디에이터의 먼지를 청소합니다.
    Informational PurposesAn informational icon, calling your attention
    참고
    라디에이터 블레이드에 너무 가까이 가지 마세요.
    Informational PurposesAn informational icon, calling your attention
    참고
    Dust and debris may fly out during the process; make sure to wear proper PPE for protection, such as a mask, safety glasses, etc.
  8. 플라스틱 그릴을 라디에이터에 고정하는 잠금 탭(8개)을 장착합니다.
  9. 액티브 그릴 셔터를 장착합니다. Active Grille Shutter (Heat Pump) (Remove and Replace)을(를) 참조하세요.
    Informational PurposesAn informational icon, calling your attention
    참고
    LV 전원 연결 후 종료합니다.
  10. 게이트웨이를 잠금 해제합니다. 참조 항목: 게이트웨이(잠금 해제).
  11. 터치스크린에서 정비 모드 "렌치"(터치스크린 UI 하단)를 탭하고 Thermal > Actions을 탭한 다음 "Test Thermal Performance" 옆에 있는 START 버튼을 탭하고 "Run"을 클릭한 후 루틴이 완료될 때까지 기다립니다.
  12. 터치스크린에서 정비 모드 "렌치"(터치스크린 UI 하단)를 탭하고 Thermal > Actions을 탭한 다음 "Test HVAC Performance" 옆에 있는 START 버튼을 탭하고 "Run"을 클릭한 후 루틴이 완료될 때까지 기다립니다.
  13. 정비 모드를 비활성화합니다. 참조 항목: Service Mode.
  14. 후드 내 보관 유닛을 장착합니다. 참조 항목: Underhood Storage Unit (Remove and Replace).
  15. LH 전면 창문을 올리고 LH 전면 도어를 닫습니다.
  16. 리프트에서 차량을 내립니다.