2023-07-13

Check Strap - Door - Rear - LH (Remove and Replace)

Correction code 10106552 0.60 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. To provide feedback on FRT values, email ServiceManualFeedback@tesla.com. NOTE: See 개인 보호 to make sure wearing proper PPE when performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.

  • 1454796-00-A 도구 키트, 창문 스위치

Remove

  1. 창문 모터/조절기 어셈블리를 탈거합니다. 창문 조절기 - 후면 - LH(탈거 및 교체)을(를) 참조하십시오.
  2. T40 비트를 사용하여 LH 후면 도어 체크 스트랩을 A필러 차체에 고정하는 볼트를 탈거합니다.
    24 Nm (17.7 lbs-ft)
    Warning IconA warning icon, calling your attention to a possibly risky situation
    경고
    도어 체크의 볼트를 풀면 도어가 개방 한계를 넘어 제한 없이 열립니다.
  3. 도어에 체크 스트랩을 고정하는 너트(2개)를 10mm 깊이의 소켓으로 탈거합니다.
    10 Nm (7.4 lbs-ft)
  4. 도어 개구부 안쪽으로 접근하여 차량에서 체크 스트랩을 탈거합니다.

Install

Installation procedure is the reverse of removal, except for the following:

  • 반드시 창문을 조정하고 보정해야 합니다.