Bracket - Edge Support - Seat Cushion - 2nd Row - LH (Remove and Replace)
Correction code
13050612
0.12
NOTE: Unless otherwise explicitly
stated in the procedure, the above correction code and FRT reflect all of the work
required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created. To provide feedback on
FRT values, email ServiceManualFeedback@tesla.com.
NOTE: See 개인 보호 to make sure wearing proper PPE when
performing the below procedure. See 인체공학적 주의 사항 for safe and healthy working practices.
Torque Specifications
Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
---|---|---|---|---|
2열 시트 쿠션 엣지 지지 브래킷을 차량에 고정하는 볼트 |
![]() 10 Nm (7.4 lbs-ft) |
|
Reuse |
Remove
- 도어 4개를 모두 엽니다.
- 창문 4개를 모두 내립니다.
- 전면부 좌석 모두를 완전히 앞으로 움직입니다.
- 2열 하단 시트 쿠션을 탈거합니다. Seat Cushion - Lower - 2nd Row (Remove and Replace)을(를) 참조하십시오.
- LH 후면 실 패널 트림을 탈거합니다. Trim - Sill Panel - Rear - LH (Remove and Replace)을(를) 참조하십시오.
-
전기 하네스를 2열 시트 쿠션 가장자리 지지 브래킷에 고정하는 클립을 연결 해제합니다.
-
2열 시트 쿠션 가장자리 지지 브래킷을 차량에 고정하는 볼트를 탈거한 후 브래킷을 차량에서 탈거합니다.
TIpUse of the following tool(s) is recommended:
- 10mm 소켓
- 4인치 익스텐션
- 래칫/토크 렌치
Install
Installation procedure is the reverse of removal.